Supplies Needed
1 tube of choice – I
used the fantastic artwork of Lisa Cree which can be purchased from her store, PSP Tube Stop. You must have a license to use.
Font of choice – I
used Kleymissky here
It can be found under Wednesday, November 20, 2013
Tutorial Supplies of elements and papers here
These supplies are for PU and for this tutorial only.
This tutorial was
written assuming you have working knowledge of PSP.
~♥~ Let’s get started ~♥~
Open up a 700 x 700 blank canvas.
Flood fill white.
Copy and paste element 5 as a new
layer.
Click inside of it with your Magic Wand.
Selections/Modify/Expand by 4.
New Raster layer below the frame.
Copy and paste Paper 2 Into
Selection.
Deselect.
Merge Visible the frame and paper.
Duplicate
Move both merged layers into
position – see my tag for reference.
New Raster layer.
Make your Selection Tool active set
on Rectangle.
Create a rectangle approximately 540
x 250 pixels.
Copy and paste Paper 1 Into
Selection.
Deselect.
Rename this layer “Rect 1”
Give the paper a slight Inner Bevel:
Move into position – see my tag for
reference.
New Raster layer above Rect 1 layer.
Make our Selection Tool active again
set on Rectangle and create a rectangle at the right side of Rect 1
approximately 150 pixels wide and longer than Rect 1.
Copy and paste Paper 3 Into
Selection.
Do Not Deselect.
Rename this layer Rect 2.
Copy and paste your tube as a new
layer over Rect 2 layer.
Change the Properties of the tube to
Soft Light.
Selections/Invert
Tap the delete key.
Highlight Rect 2 layer.
Tap the delete key.
Give it the same slight Inner Bevel.
Deselect.
New Raster layer at the top of your
layers pallet.
Make your Selection Tool active set
on Rectangle and create a rectangle approximately 260 x 425 pixels.
Copy and paste Paper 3 Into
Selection.
Give it the same slight Inner Bevel.
Deselect.
Move into position – see my tag for
reference.
Rename this layer Rect 3.
Copy and paste element 2 as a new
layer.
Duplicate
Move each one behind Rect 3 – see my
tag for reference.
To get rid of the excess:
Use your Selection tool to section
off what overhangs the rectangle, highlight the element layer and then tap the
delete key.
Deselect.
Copy and paste the element again.
Repeat the above step accept move
into position behind Rect 2.
Copy and paste element 1.
Repeat the above step accept move
into position behind the elements of Rect 3 – see my tag for reference.
Add the remaining elements,
duplicating elements of your choice.
Copy and paste your tube as a new
layer.
Move into position in front of the
circle frame – see my tag for reference.
Highlight your white background.
Select All.
Copy and paste Paper 3 Into
Selection.
Deselect.
Apply the mask.
Resize 110%
Merge Group.
Flip
Add your copyrights.
Add your name.
Foreground: #000000
Background: #45708b
Stroke: 0.8
Type your name.
Give it a slight Inner Bevel 2x’s:
Crop your Image.
Resize all layers 80%.
I’d love to see your results.
Hugs,
Bev
No comments:
Post a Comment