Friday, January 13, 2012

His Valentine


1 tube of choice – I used the wonderful artwork of Elias Chatzoudis which can be purchased from PSP Tubes Emporium.  You must have a license to use.

Font of choice - I used Anglo Saxon here

JWY_Mask 10 here

Plugs Ins:
Mura’s Meister - Copies

“Ambrosia Dream” is a tagger size scrap kit created by Pixie of KissedbyPix Designs and can be purchased from her store TKO Scraps  You can visit her blog here
Thank you Pixie for another fantastic kit.

This tutorial was written assuming you have a working knowledge of PSP.

~~ Lets get started ~~

Open upa 700 x 700 blank canvas.
Flood fill white.

New Raster layer.
Make your Selection Tool active set on Rectangle.
Create a rectangle approximately 350 x 500 pixels.
Copy and paste Paper 2 as a new layer.
Resize 70%
Tap the delete key.
Copy and paste Paper 4 as a new layer.
Resize 70%
Tap the delete key.

Give both papers a slight Inner Bevel:
Move both paper layers into position – see my tag for reference.

Copy and paste your tube as a new layer.
Position in front of the yellow rectangle.

Copy and paste your tube again.
Position this one in the upper left area of the yellow rectangle.
In your layers pallet move it just above the yellow rectangle.
Highlight the yellow rectangle.
Click anywhere outside of it with your Magic Wand.
Highlight the tube layer.
Tap the delete key.
Change the Properties to Multiply.
Lower the Opacity to about 44.

Add your elements.  I used:
Banner 3:  Resize 60%
Heart Frame 4:  Resize 10%/Duplicate
Heart Frame 2:  Resize 10%/Duplicate
Heart Frame 4:  Resize 40%/Duplicate
Beaded Heart 7:  Resize 25%/Free rotate Left 20 degrees/Duplicate/Mirror/Resize 70%
Curly 2:  Resize 45%

Close out your white canvas.
Merge Visible.
Reopen your white canvas.

Duplicate the merged layer.
Move the duplicate layer below the original.
Apply Mura’s Meister – Copies:
Set it on Wallpaper
Adjust/Blur/Gaussian Blur:
Radius: 15
Apply the mask.
Merge Group.

Add your name.
Color Pallet:
Foreground and Background: #ffefc6
Type each letter on their own layer and used the Pick Tool to slant each letter so it slants to match the ribbon.
Merge Visible all letter layers.
Apply the same slight Inner Bevel.

I’d love to see your results.
Email me!

No comments:

Post a Comment